One-for-all URC-7562 Manuel d'utilisateur télécharger pdf (Page 11)

WWW.ONEFORALL.COM 11

Device Sleeptimer

If your TV or Satellite has a “Sleeptimer” function built in, you can access

this function with your ONE FOR ALL remote. To do so:

1 Make sure your TV (or Satellite) is switched on.

2 Press the device key (TV or SAT).

3 Point the ONE FOR ALL at your TV (or Satellite) and press and relea-

se MAGIC then press POWER. You should see the Sleeptimer activa-

te on your TV screen.

To increase the timer, simply press POWER again (within 5 seconds)

until the timer gets to the desired time.

To deactivate the Sleeptimer, repeat steps 1-3 above. During step 3, continue

pressing POWER (within 5 seconds) until the timer indicates zero minutes.

ONE FOR ALL Sleeptimer

If your device does not have a sleeptimer function built in, you can install

the ONE FOR ALL sleeptimer function. To do so:

1 Press the device key (TV, SAT, CD or AUD).

2 Then, press and hold MAGIC until the device key blinks twice.

3 Press 970. The device key will blink twice again. It is only necessary

to perform steps 1, 2 and 3 once. Now to set the timer, continue

with the steps below.

Setting the ONE FOR ALL Sleeptimer:

It is possible to set the timer for 15, 30, 45 or 60 minutes. To do this, first

make sure your device is switched on.

Press the device key (TV, SAT, CD or AUD).

Now, press and release MAGIC, then press POWER.

The device key will blink once which indicates the timer is

set for 15 minutes. To increase the timer, simply press

POWER again (this must be done within 5 seconds). The

device key will blink twice indicating the timer is set for 30

minutes (2x 15). You can press POWER to a maximum of

four times which will set the timer to 60 minutes.

Once you have set the timer to the desired time, set your ONE FOR ALL

remote down, pointing it at your device. When the programmed amount

of time has elapsed, the ONE FOR ALL will send the command for POWER,

hence turning off your device.

Important note: Depending on how you used sleeptimer on the original

remote, you might need to access sleeptimer in a different way (through

menu for example).

Important notes:

- The device key on the ONE FOR ALL will blink every 15 seconds indicating

that the remote is in Sleeptimer mode.

- To deactivate the Sleeptimer, simply press any key on the ONE FOR ALL

remote.

- Also, it is only necessary to follow steps 1,2 and 3 above once. For subse-

quent use of the Sleeptimer, simply begin with “Setting the Sleeptimer”.

- To switch the ONE FOR ALL back to Device Sleeptimer, repeat steps 1,2 and

3 above. The device key will blink 4 times.

- Remember, when using the ONE FOR ALL Sleeptimer, you must set the

remote so it is pointing to your device.

- The ONE FOR ALL Sleeptimer can be set up for only one device at a time.

(:15)

(:30)

(:45)

(:60)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

One-for-all URC-7562 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôle à distance One-for-all URC-7562